I want to CNC my sprocket and pulley. For that the rear wheel must be dismounted – no big stuff.

These are the tools:

• 5/32 HEX
• 3/16 HEX
• 5/16 HEX
• 9/16 NUT
• 3/8 HEX
• 22 HEX (metric)
• 22 NUT (metric)

Terms and conditions: All work at own risk, NO warranty in ANY case of damage!

STEP 1
At first it is necessary to dismount the sprocket cover. On mine its the RRC cover with one 5/32 HEX and two 3/16 HEX.

Step 2
Now for the rear brake. Unscrew the two  5/16 HEX on the swingarm and make sure the rear caliper is secured.

Step 3
Now for the axle lock pin, lose it with a 3/8 HEX. After that you can loosen the axis with the metric 22 HEX. Try not to dissemble the axis this is just for loosen the belt tension!

STEP 4
Now its time to take off the idler pulley. First step is to unscrew the two nuts with a  9/16 NUT. Then you can strip it away from the belt.

STEP 5
Now you can loosen and remove the rear axis and remove the wheel.